6
Sheet No.: D3-A01001EN
GP1S196HCZ0F/GP1S196HCZSF
?SPAN class="pst GP1S196HCZ0F_2584553_4">Design Considerations
?/DIV>
Design guide
1) Prevention of detection error
To prevent photointerrupter from faulty operation caused by external light, do not set the detecting face to
the external light.
2) Position of opaque board
Opaque board shall be installed at place 1.4mm or more from the top of elements.
(Example)
This product is not designed against irradiation and incorporates non-coherent IRED.
?/DIV>
Degradation
In general, the emission of the IRED used in photointerrupter will degrade over time.
In the case of long term operation, please take the general IRED degradation (50% degradation over 5
years) into the design consideration.
?/DIV>
Recommended Foot Print (Only for GP1S196HCZSF)
1.4mm or more
1.4mm or more
3.7
1.65
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
GP1S51VJ000F
SENSOR OPTO SLOT 3MM TRANS THRU
GP1S52VJ000F
SENSOR OPTO SLOT 3MM TRANS THRU
GP1S53VJ000F
SENSOR OPTO SLOT 5MM TRANS THRU
GP1S560J000F
SENSOR OPTO SLOT 2MM TRANS THRU
GP1S56TJ000F
SENSOR OPTO SLOT 2MM TRANS THRU
GP1S58VJ000F
SENSOR OPTO SLOT 5MM TRANS THRU
GP1S59J0000F
SENSR OPTO SLOT 4.2MM TRANS THRU
GP1S74PJ000F
SENSOR OPTO SLOT 5MM TRANS CONN
相关代理商/技术参数
GP1S196HCZSF
功能描述:光学开关（透射型，光电晶体管输出） Photointerrupter Sub mini 1.0mm gap RoHS:否 制造商:Omron Electronics 输出设备:Phototransistor 槽宽:3.4 mm 光圈宽度:0.5 mm 集电极—发射极最大电压 VCEO:30 V 最大集电极电流:20 mA 正向电流: 安装风格:Through Hole 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装:
GP1S20
制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:SUBMINIATURE PHOTOINTERRUPTER
GP1S21
制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Subminiature Photointerrupter
GP1S22
制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Subminiature Photointerrupter
GP1S23
制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Subminiature Photointerrupter
GP1S23J0000F
制造商:Sharp Microelectronics Corporation 功能描述:PHOTOINTERRUPTER SUB MIN
GP1S24
制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Subminiature Photointerrupter
GP1S25
功能描述:PHOTOINTERRUPTER SLOT 1.6MM PCB RoHS:否 类别:传感器，转换器 >> 光学 - 光断续器 - 槽型 - 晶体管输出 系列:- 产品变化通告:Internal Chip Change 04/May/2007 标准包装:100 系列:- 检测距离:0.063"（1.6mm） 检测方法:可传导的 输出配置:光电晶体管 电流 - DC 正向(If):50mA 电流 - 集电极 (Ic)（最大）:20mA 电压 - 集电极发射极击穿（最大）:35V 响应时间:35µs，35µs 安装类型:通孔 封装/外壳:PCB 安装 包装:管件 类型:无放大 工作温度:-25°C ~ 85°C 其它名称:425-1978-5